“CAT ET 2026 Diagnostic Software” has been added to your cart. View cart
The oil thermostat is located in the oil filter housing and controls the engine oil temperature by controlling if the oil is sent through the oil cooler or not. The Engine Control Module (ECM) monitors that the thermostat is working as expected by comparing the Engine Oil Pressure (EOP) Sensor value to a calculated oil temperature.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:53 is between 33?% and 67?% of the battery voltage
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Increased fuel consumption
2) Low oil temperature
Probable cause
1) Open circuit on common supply wire or open circuit on fuse FE9
2) Open circuit in the valve
3) Open circuit in component
Related products
-
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 3719 FMI 16 (ACM) Soot Level High
DD16 EPA10 (2010-13) -
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 100 FMI 1 (MCM) Low Engine Oil Pressure
DD16 GHG14 (2014-16) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 3464 FMI 7 PID: Engine Throttle Actuator 1 Control Command
All Engines (2010 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P100212 PID: EMS Preheat Relay
All Engines (2013 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P027100 PID: EMS Injector 4 Short Circuit High
All Engines (2017 Emissions)