Volvo All Engines (2010 Emissions) Fault Code: SPN 4813 FMI 5 PID: PSID 72 Engine Oil Thermostat Bypass Valve Opening
The oil thermostat is located in the oil filter housing and controls the engine oil temperature by controlling if the oil is sent through the oil cooler or not. The Engine Control Module (ECM) monitors that the thermostat is working as expected by comparing the Engine Oil Pressure (EOP) Sensor value to a calculated oil temperature.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:53 is between 33?% and 67?% of the battery voltage
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Increased fuel consumption
2) Low oil temperature
Probable cause
1) Open circuit on common supply wire or open circuit on fuse FE9
2) Open circuit in the valve
3) Open circuit in component
![Magic Tuner [paccar, Maxxforce, Detroit, Caterpillar, Delete]](https://www.ecuforcetruck.com/wp-content/uploads/2021/10/1-300x300.png)
![Volvo Penta EPC 6 Offline VMware [12.2021] VMware](https://www.ecuforcetruck.com/wp-content/uploads/2022/11/VOLVO-PENTA-2021-A-300x300.jpg)
Related products
-
-
Volvo All Engines (2013 Emissions) Fault Code: P215A62 PID: EMS Vehicle Speed – Wheel Speed Correlation
All Engines (2013 Emissions) -
-
Volvo All Engines (2017 Emissions) Fault Code: P10AF00 PID: ACM Reductant Pump “A” Control Low Side High
All Engines (2017 Emissions) -
-
-
Volvo Engine D12D AE E3 (Tier 3) Fault Code: PID153 FMI 3 Crankcase Pressure
D12D AE E3 (Tier 3) -
-
-
Volvo All Engines (2017 Emissions) Fault Code: P050600 PID: EMS Idle Control System – RPM Lower Than Expected
All Engines (2017 Emissions) -
-
Volvo All Engines (2017 Emissions) Fault Code: P063000 PID: ACM VIN Not Programmed or Incomplete – ECM/PCM
All Engines (2017 Emissions) -
-
-
-
-
-
