This diagnostic trouble code (DTC) detects faults in the main software. Faulty main software can result in engine no start symptoms.
Conditions for diagnostic trouble code (DTC):
1) Checksum fault
Observable symptoms
1) Engine does not start
Probable cause
1) Engine control module (ECM)
2) Programmed with erroneous software
3) Programming sequence interrupted
-
Hino Diagnostic eXplorer 2 – Hino DX2 1.1.19.1 with keygen unlocked ( Hino trucks )
Hino $50.00Rated 0 out of 5 -
Navistar international OnCommand service information 2018 software trucks
Navistar $50.00Rated 0 out of 5 -
VOLVO PREMIUM TECH TOOL PTT 2.7.30 Developer + Devtool + INSTALATION VIDEO!
Trucks software $60.00Rated 0 out of 5 -
Wabco ToolBox plus 13.7 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software $84.00Rated 0 out of 5 -
PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks
PACCAR $60.00Rated 0 out of 5 -
International Truck ISIS – Oncommand Service Information Q4.2020 [04.2020]
Navistar $85.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2684 Actuator Supply Circuit Voltage 3 Open (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2723 Pressure Control Solenoid 1 (PCS1) – Stuck Off
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2670 Actuator Supply Voltage 2 (HSD2) – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2669 Actuator Supply Voltage 2 Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2730 Pressure Control Solenoid 1 (PCS1) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P097C Shift Solenoid 3 (SS3) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2724 Pressure Control Solenoid 1 (PCS1) – Stuck On
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2789 Clutch Adaptive Learning at Limit
1000 & 2000 Gen 5Rated 0 out of 5
-
Volvo All Engines (2013 Emissions) Fault Code: P22FE00 PID: EMS ISO/SAE Reserved
All Engines (2013 Emissions)Rated 0 out of 5 -
Volvo Engine D12D AE E3 (Tier 3) Fault Code: PID94 FMI 1 Fuel Feed Pressure
D12D AE E3 (Tier 3)Rated 0 out of 5 -
PACCAR MX (2004 Emissions) Fault Code: P1694 Cold Starting Aid – Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (C72) or Pin (C49)
MX (2004 Emissions)Rated 0 out of 5 -
PACCAR MX (2004 Emissions) Fault Code: P0571 CAN Communication – Message (CCVS) Out of Range, Brake Switch from Vehicle Control System
MX (2004 Emissions)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 520268 FMI 18 (MCM) Fuel Rail Pressure Too High, Similar Condition
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P26977A PID: EMS Exhaust Aftertreatment Fuel Injector “A”
All Engines (2017 Emissions)Rated 0 out of 5 -
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 973 FMI 19 (CPC) Engine Retarder Selection Signal is Erratic
DD15 EPA07 (2007-09)Rated 0 out of 5 -
Volvo All Engines (2010 Emissions) Fault Code: SPN 153 FMI 0 PID: PSID 23 Engine High Resolution Crankcase Pressure
All Engines (2010 Emissions)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P048013 PID: EMS Fan 1 Control Circuit
All Engines (2017 Emissions)Rated 0 out of 5 -
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 636 FMI 1 (MCM) Crankshaft Position Sensor Signal Voltage Too Low
DD15 EPA07 (2007-09)Rated 0 out of 5