Volvo All Engines (2010 Emissions) Fault Code: SPN 633 FMI 4 PID: SID 18 Engine Fuel Actuator 1 Control Command
The Engine Control Module (ECM) uses water in fuel sensor/switch to monitor the water level in the fuel pre-filter. When it is time for drainage a water level warning is indicated in the instrument. It?s possible to activate the function when draining is needed. When the function is activated the water in fuel valve is opened and the water drained from the fuel system. Faulty water in fuel valve can lead to that the valve is constantly shut.
Conditions for diagnostic trouble code (DTC):
1) Short circuit to battery voltage on A14.EA:3
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) The solenoid valve cannot be activated
2) Water drainage is not possible
Probable cause
1) Connector
2) Wiring harness
3) Drain valve, water in fuel
Related products
-
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 2791 FMI 3 (MCM) Circuit Failed High
DD15 EPA07 (2007-09) -
Volvo All Engines (2017 Emissions) Fault Code: P054100 PID: EMS Intake Air Heater A Circuit Low
All Engines (2017 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P020413 PID: EMS Cylinder 4 Injector “A”
All Engines (2017 Emissions) -
-
-
Volvo All Engines (2017 Emissions) Fault Code: P020A25 PID: EMS Cylinder 1 Injection timing
All Engines (2017 Emissions) -
-
-
-
-
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 91 FMI 3 (CPC) Circuit Failed High
DD15 EPA10 (2010-13) -
-
Volvo All Engines (2013 Emissions) Fault Code: P114101 PID: EMS Buffered Idle Validation Switch Wire – ECM Side
All Engines (2013 Emissions) -
-
-
-
-
