Volvo All Engines (2010 Emissions) Fault Code: SPN 633 FMI 5 PID: SID 18 Engine Fuel Actuator 1 Control Command
The Engine Control Module (ECM) uses water in fuel sensor/switch to monitor the water level in the fuel pre-filter. When it is time for drainage a water level warning is indicated in the instrument. It?s possible to activate the function when draining is needed. When the function is activated the water in fuel valve is opened and the water drained from the fuel system. Faulty water in fuel valve can lead to that the valve is constantly shut.
Conditions for diagnostic trouble code (DTC):
1) Short circuit to battery voltage on A14.EA:3
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) The solenoid valve cannot be activated
2) Water drainage is not possible
Probable cause
1) Connector
2) Wiring harness
3) Drain valve, water in fuel
Related products
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 16 PID: SPN: 173 FMI: 0 High Exhaust Gas Temperature Derate
3406E (Prefix 1MM or 2WS) -
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P20D711 PID: EMS Exhuast Aftertreatment Fuel Supply Control
All Engines (2013 Emissions) -
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P215A64 PID: EMS Vehicle Speed – Wheel Speed Correlation
All Engines (2013 Emissions) -
-
-
Volvo All Engines (2004 Emissions) Fault Code: PID 98 FMI 4 Engine Oil Level / Temperature Sensor
All Engines (2004 Emissions) -
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 132 FMI 1 (MCM) Air Mass Flow Too Low
DD16 EPA07 (2007-09) -
