Volvo All Engines (2010 Emissions) Fault Code: SPN 677 FMI 3 PID: SID 39 Engine Starter Motor Relay
The (VECU) Vehicle Electronic Control Unit supplies and monitors the cranking signal to the starter motor relay. Several types of starter cranking protection are provided so the starter cannot be engaged in unwanted conditions. The starter cranking protection will also limit the maximum cranking time to 18 seconds without cycling the key
Conditions for diagnostic trouble code (DTC):
1) Output A14.EB:29 active
2) Short circuit to battery voltage
3) This diagnostic trouble code (DTC) is set only when the ignition key is held in the start position for approximately 3?s
Observable symptoms
1) Starter motor does not run
Probable cause
1) Wire between Engine Control Module (ECM) and starter motor relay
2) Starter motor relay (K65)
Related products
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 91 FMI 9 PID: Accelerator Pedal Position 1
All Engines (2010 Emissions) -
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 3064 FMI 11 PID: PPID 326 Aftertreatment DPF Soot Level
All Engines (2010 Emissions) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P268F00 PID: EMS Cylinder 4 Injector Data Incompatible
All Engines (2013 Emissions) -
Allison 3000 & 4000 Gen 4 Fault Code: P2761 TCC PCS Control Circuit Open
3000 & 4000 Gen 4 -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P04007C PID: EMS Exhaust Gas Recirculation “A” Flow
All Engines (2013 Emissions) -
-
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4334 FMI 7 (ACM) DEF Pressure Low
DD13 EPA10 (2010-13) -
Volvo All Engines (2013 Emissions) Fault Code: P06E800 PID: EMS Sensor Power Supply “C” Circuit High
All Engines (2013 Emissions) -
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3510 FMI 3 (CPC) High Voltage
DD15 EPA10 (2010-13)
