The Fuel Pressure Sensor is used to detect low fuel pressure system failures. The sensor consists of a pressure sensitive diaphragm and amplifier. Fuel pressure causes the sensor’s diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor’s signal is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:16 is less than 0.2?V
Diagnostic monitor condition
1) Key in ON position
Probable cause
1) Open circuit, Signal wire
2) Open circuit, Supply wire
3) Engine wiring harness
4) Engine Fuel Pressure Sensor
Related products
-
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 558 FMI 3 (CPC) Open Circuit
DD15 EPA07 (2007-09) -
Volvo All Engines (2017 Emissions) Fault Code: P056300 PID: ACM ECU Battery Potential Below Range
All Engines (2017 Emissions) -
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 986 FMI 9 (CPC) CM1 Message is Missing
DD16 EPA10 (2010-13) -
Volvo All Engines (2017 Emissions) Fault Code: P25A971 PID: EMS Piston Cooling Oil Control
All Engines (2017 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 12 PID: Engine Intake Manifold
All Engines (2010 Emissions) -
PACCAR MX (2004 Emissions) Fault Code: P1484 EGR Valve Module – Internal Error
MX (2004 Emissions)