The Fuel Pressure Sensor is used to detect low fuel pressure system failures. The sensor consists of a pressure sensitive diaphragm and amplifier. Fuel pressure causes the sensor’s diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor’s signal is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:16 is less than 0.2?V
Diagnostic monitor condition
1) Key in ON position
Probable cause
1) Open circuit, Signal wire
2) Open circuit, Supply wire
3) Engine wiring harness
4) Engine Fuel Pressure Sensor
Related products
-
PACCAR MX (2004 Emissions) Fault Code: U179E CAN – Message (TSC1 xxe) Time-Out
MX (2004 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 153 FMI 3 PID: PSID 23 Engine High Resolution Crankcase Pressure
All Engines (2010 Emissions) -
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 29 PID: SPN: 30 FMI: 13 PTO Throttle out of calibration
3406E (Prefix 1MM or 2WS) -
Volvo All Engines (2017 Emissions) Fault Code: P040397 PID: EMS EGR “A” Control
All Engines (2017 Emissions)