Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 0 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The fuel contains water
2) Defective sensor
Observable symptoms
1) Limited engine speed: 2100rpm.
2) Engine power reduced to 28%
Probable cause
1) Water in the fuel bowl in the fuel filter housing
2) Engine control module (ECM): Defective or faulty
3) Defective sensor
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 723 FMI 3 (MCM) Open Circuit
DD13 EPA10 (2010-13) -
-
Volvo All Engines (2017 Emissions) Fault Code: P220F93 PID: EMS NOx Sensor Incorrect Value at Startup
All Engines (2017 Emissions) -
-
Volvo All Engines (2017 Emissions) Fault Code: P20A000 PID: ACM Reductant Purge Control Valve
All Engines (2017 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 730 FMI 4 PID: SID 71 Intake Air Heater (IAH) 2
All Engines (2010 Emissions) -
-
-
-
-
-
-
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 709 FMI 4 (MCM, CPC) Short to Ground
DD13 EPA10 (2010-13) -
