Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 3 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) Short circuit to battery voltage on A14.EB:8
Observable symptoms
1) Indicator does not work
2) Water in the fuel can lead to engine failure
3) Low Power
Probable cause
1) Faulty sensor
2) Short circuit to voltage supply, signal wire
3) Connector
4) Engine control module (ECM)
Related products
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P110511 PID: EMS Engine Rear Start Switch “A” Circuit
All Engines (2013 Emissions) -
-
Volvo All Engines (2013 Emissions) Fault Code: P222612 PID: EMS Barometric Pressure Circuit
All Engines (2013 Emissions) -
-
-
Allison 3000 & 4000 Gen 4 Fault Code: P0880 TCM Power Input Signal
3000 & 4000 Gen 4 -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P26047F PID: EMS Intake Air Heater “A” Circuit Range/Performance
All Engines (2017 Emissions) -
-
-
Volvo All Engines (2017 Emissions) Fault Code: P06E718 PID: ACM Sensor Power Supply “C”
All Engines (2017 Emissions) -
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 639 FMI 14 (CPC) Data Link Failure
DD16 GHG14 (2014-16) -
