Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 3 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) Short circuit to battery voltage on A14.EB:8
Observable symptoms
1) Indicator does not work
2) Water in the fuel can lead to engine failure
3) Low Power
Probable cause
1) Faulty sensor
2) Short circuit to voltage supply, signal wire
3) Connector
4) Engine control module (ECM)
Related products
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P066613 PID: EMS Control Module Internal Temperature Sensor “A”
All Engines (2013 Emissions) -
-
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P26977A PID: EMS Exhaust Aftertreatment Fuel Injector “A”
All Engines (2017 Emissions) -
-
-
Allison 3000 & 4000 Gen 4 Fault Code: P0882 TCM Power Input Signal Low
3000 & 4000 Gen 4 -
Volvo All Engines (2013 Emissions) Fault Code: P20DD12 PID: EMS Exhaust Aftertreatment Fuel Pressure Sensor
All Engines (2013 Emissions) -
-
Volvo All Engines (2017 Emissions) Fault Code: P065712 PID: EMS Actuator Supply Voltage “A” Circuit / Open
All Engines (2017 Emissions)
