Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:8 is less than 1.2?V
Observable symptoms
1) Water in the fuel can lead to engine failure
Probable cause
1) Faulty sensor
2) Wiring harness
3) Connector
Related products
-
-
Volvo All Engines (2017 Emissions) Fault Code: P242A64 PID: EMS Exhaust Gas Temperature Sensor Bank 1 Sensor 3
All Engines (2017 Emissions) -
-
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P056084 PID: ACM System Voltage
All Engines (2017 Emissions) -
-
-
-
-
-
-
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 91 FMI 13 (CPC) Data Out of Calibration
DD16 GHG14 (2014-16) -
-
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 21 PID: SPN: 41 FMI: 3 8 Volt Supply voltage high
3406E (Prefix 1MM or 2WS)
