Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator
Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:8 is less than 1.2?V
Observable symptoms
1) Water in the fuel can lead to engine failure
Probable cause
1) Faulty sensor
2) Wiring harness
3) Connector
![DAF Davie Runtime v5.6.1 Davie XDc ll [02.2019] + Expire Fix 302.00 Unlock ( Windows 7 )](https://www.ecuforcetruck.com/wp-content/uploads/2021/09/Capture-2-300x300.png)
Related products
-
-
-
-
-
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5
-
-
-
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 14 PID: SPN: 121 FMI: 5 Low/High Retarder current low
3406E (Prefix 1MM or 2WS) -
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P020556 PID: EMS Cylinder 5 Injector “A”
All Engines (2013 Emissions) -
-
-
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 21 PID: SPN: 41 FMI: 3 8 Volt Supply voltage high
3406E (Prefix 1MM or 2WS) -
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 21 PID: 41 SPN: FMI: 3 8 Volt Supply voltage high
3406E (Prefix 5DS or 1LW) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P114412 PID: EMS Starter Relay Highside
All Engines (2013 Emissions)
