Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator

Category All Engines (2010 Emissions) Tags 2010, 5, 97, All, CodeSPN, Emissions, Engines, Fault, FMI, Fuel, In, Indicator, PID, Volvo, Water

Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.

Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:8 is less than 1.2?V

Observable symptoms
1) Water in the fuel can lead to engine failure

Probable cause
1) Faulty sensor
2) Wiring harness
3) Connector

CAT
CAT ET 2026 Diagnostic Software
$110.00 Add to cart
Detroit
DETROIT DIESEL DIAGNOSTIC LINK 8.23 SP2 2026
$120.00 Add to cart
Detroit
DETROIT DIESEL DIAGNOSTIC LINK DDDL 8.20 SP1 2025
$110.00 Add to cart
John Deere
John Deere Service Advisor 5.4.44 2025 (AG & CF) | Nexiq USB Link 3 Compatible
$420.00 Add to cart

Eaton Service Ranger 4 4.2 database 2017
Eaton $50.00
Hino DX3 1.22.10 2022 ( 1 PC )
Hino $96.00
PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks
PACCAR $60.00

Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator

CAT ET 2026 Diagnostic Software

DETROIT DIESEL DIAGNOSTIC LINK 8.23 SP2 2026

DETROIT DIESEL DIAGNOSTIC LINK DDDL 8.20 SP1 2025

John Deere Service Advisor 5.4.44 2025 (AG & CF) | Nexiq USB Link 3 Compatible

Eaton Service Ranger 4 4.2 database 2017

Hino DX3 1.22.10 2022 ( 1 PC )

PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks

Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 442 PID: PID 168 SPN: 168 FMI: 16 Battery 1 Voltage- Data Valid But Above Normal Operational Range- Moderately Severe Level

Detroit DD15 GHG14 (2014-16) Fault Code: SPN 2791 FMI 10 (MCM) Coolant Temperature High-Alarm

Eaton Fuller Advantage (2017) Fault Code: 58 PID: SPN: 191 FMI: 8 Output Shaft Speed Sensor: Abnormal Frequency

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 352 PID: SID 212 SPN: 3509 FMI: 4 Sensor Supply 1 Circuit- Voltage Below Normal or Shorted to Low Source

Volvo All Engines (2017 Emissions) Fault Code: P20BB00 PID: EMS Aftertreatment Reagent Hose Heater 1 Short Circuit Low

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 3364 FMI 18 (ACM) Improper Diesel Exhaust Fluid Quality Warning

Detroit DD13 GHG14 (2014-16) Fault Code: SPN 702 FMI 3 (CPC) Top 2 Shift Solenoid – Indicates a Short to Power on Pin 08 Circuit of the CPC #3 Connector.

Cummins ISB CM850 (2003-06) Fault Code: 1143 PID: SID 4 SPN: 654 FMI: 7 Injector Solenoid Driver Cylinder 4 – Mechanical System Not Responding Properly or Out of Adjustment. Unintended fueling detected in cylinder number 4.

Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 3343 PID: SPN: 5285 FMI: 18 Engine Charge-Air Cooler Efficiency- Data Valid But Below Normal Operating Range- Moderately Severe Level

Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 515 PID: SID 232 SPN: 3514 FMI: 3 Sensor Supply 6 Circuit- Voltage Above Normal or Shorted to High Source

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 3254 PID: SPN: 3242 FMI: 15 Aftertreatment Diesel Particulate Filter Intake Temperature- Data Valid But Above Normal Operating Range- Least Severe Level

Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 4235 PID: SPN: 3521 FMI: 11/31 Aftertreatment 1 Diesel Exhaust Fluid Property – Condition Exists

Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 1677 (HW) PID: SPN: 3031 FMI: 4 Aftertreatment 1 Diesel Exhaust Fluid tank Temperature Sensor- Voltage Below Normal or Shorted to Low Source

Cummins ISM CM875 (2003-06) Fault Code: 187 PID: S232 SPN: 1080 FMI: 4/4 Sensor Supply 2 Circuit – Voltage Below Normal or Shorted to Low Source. Low voltage detected at the sensor supply number 2 circuit.

PACCAR MX (2004 Emissions) Fault Code: P1105 Engine Protection System – Approaching Engine Shutdown

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 442 PID: 168 SPN: 168 FMI: 0 Battery 1 Voltage – Data Valid but Above Normal Operational Range – Moderately Severe Level. ECM supply voltage is above the maximum system voltage level.

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 323 PID: SID 5 SPN: 655 FMI: 5 Injector Solenoid Driver Cylinder 5 Circuit- Current Below Normal or Open Circuit

Store

About

Features

Follow Us

Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 5 PID: Water in Fuel Indicator

CAT ET 2026 Diagnostic Software

DETROIT DIESEL DIAGNOSTIC LINK 8.23 SP2 2026

DETROIT DIESEL DIAGNOSTIC LINK DDDL 8.20 SP1 2025

John Deere Service Advisor 5.4.44 2025 (AG & CF) | Nexiq USB Link 3 Compatible

Eaton Service Ranger 4 4.2 database 2017

Hino DX3 1.22.10 2022 ( 1 PC )

PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks

Related products

Allison 1000 & 2000 Gen 5 Fault Code:P0977 Shift Solenoid 2 (SS2) Control Circuit – High

Allison 1000 & 2000 Gen 5 Fault Code:P0973 Shift Solenoid 1 (SS1) Control Circuit – Low

Allison 1000 & 2000 Gen 5 Fault Code:P2730 Pressure Control Solenoid 1 (PCS1) Control Circuit – High

Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A

Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open

Allison 1000 & 2000 Gen 5 Fault Code:P2724 Pressure Control Solenoid 1 (PCS1) – Stuck On

Allison 1000 & 2000 Gen 5 Fault Code:P1790 Gear Shift Module 1 Calibration Invalid

Allison 1000 & 2000 Gen 5 Fault Code:P1892 Throttle Position Sensor (TPS) PWM Signal – High Input

Allison 1000 & 2000 Gen 5 Fault Code:P2723 Pressure Control Solenoid 1 (PCS1) – Stuck Off

Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low

Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High

Allison 1000 & 2000 Gen 5 Fault Code:P2684 Actuator Supply Circuit Voltage 3 Open (HSD3)

Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 442 PID: PID 168 SPN: 168 FMI: 16 Battery 1 Voltage- Data Valid But Above Normal Operational Range- Moderately Severe Level

Detroit DD15 GHG14 (2014-16) Fault Code: SPN 2791 FMI 10 (MCM) Coolant Temperature High-Alarm

Eaton Fuller Advantage (2017) Fault Code: 58 PID: SPN: 191 FMI: 8 Output Shaft Speed Sensor: Abnormal Frequency

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 352 PID: SID 212 SPN: 3509 FMI: 4 Sensor Supply 1 Circuit- Voltage Below Normal or Shorted to Low Source

Volvo All Engines (2017 Emissions) Fault Code: P20BB00 PID: EMS Aftertreatment Reagent Hose Heater 1 Short Circuit Low

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 3364 FMI 18 (ACM) Improper Diesel Exhaust Fluid Quality Warning

Detroit DD13 GHG14 (2014-16) Fault Code: SPN 702 FMI 3 (CPC) Top 2 Shift Solenoid – Indicates a Short to Power on Pin 08 Circuit of the CPC #3 Connector.

Cummins ISB CM850 (2003-06) Fault Code: 1143 PID: SID 4 SPN: 654 FMI: 7 Injector Solenoid Driver Cylinder 4 – Mechanical System Not Responding Properly or Out of Adjustment. Unintended fueling detected in cylinder number 4.

Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 3343 PID: SPN: 5285 FMI: 18 Engine Charge-Air Cooler Efficiency- Data Valid But Below Normal Operating Range- Moderately Severe Level

Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 515 PID: SID 232 SPN: 3514 FMI: 3 Sensor Supply 6 Circuit- Voltage Above Normal or Shorted to High Source

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 3254 PID: SPN: 3242 FMI: 15 Aftertreatment Diesel Particulate Filter Intake Temperature- Data Valid But Above Normal Operating Range- Least Severe Level

Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 4235 PID: SPN: 3521 FMI: 11/31 Aftertreatment 1 Diesel Exhaust Fluid Property – Condition Exists

Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 1677 (HW) PID: SPN: 3031 FMI: 4 Aftertreatment 1 Diesel Exhaust Fluid tank Temperature Sensor- Voltage Below Normal or Shorted to Low Source

Cummins ISM CM875 (2003-06) Fault Code: 187 PID: S232 SPN: 1080 FMI: 4/4 Sensor Supply 2 Circuit – Voltage Below Normal or Shorted to Low Source. Low voltage detected at the sensor supply number 2 circuit.

PACCAR MX (2004 Emissions) Fault Code: P1105 Engine Protection System – Approaching Engine Shutdown

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 442 PID: 168 SPN: 168 FMI: 0 Battery 1 Voltage – Data Valid but Above Normal Operational Range – Moderately Severe Level. ECM supply voltage is above the maximum system voltage level.

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 323 PID: SID 5 SPN: 655 FMI: 5 Injector Solenoid Driver Cylinder 5 Circuit- Current Below Normal or Open Circuit

Store

About

Features

Follow Us