The Engine Oil Temperature/Level Sensor contains two resistors: One for engine oil temperature and one for engine oil level.
Diagnostic trouble code (DTC) Placeholder will be present only when a problem with the engine oil level (EOL) circuit has failed. Please reference Placeholder for engine oil temperature (EOT) sensor circuit diagnostics.
The resistance of the engine oil level portion of the sensor changes inversely to the level of the engine oil. The Engine Control Module (ECM) monitors the voltage drop across the sensor and uses this signal to warn that the engine oil level is not within programmed limits. In some cases the engine will derate.
The engine oil level is monitored when the key is on, before the starter is engaged. If low engine oil is detected, either from parking on an incline, or actual low oil, the code will remain active until the next key cycle. It is important that the vehicle is level during key on, or the low engine oil level code may remain.
Conditions for diagnostic trouble code (DTC):
1) Engine oil level (EOL) is below warning level
Probable cause
1) Vehicle Not Parked On a Level Surface.
2) Low oil level
3) Connector
4) Engine Oil Dipstick
5) Engine oil level (EOL) and temperature sensor
Detailed information
1) Engine may have to be off up to 20 minutes depending on temperature before checking the oil level.
Related products
-
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 21 PID: 41 SPN: FMI: 4 8 Volt Supply voltage low
3406E (Prefix 5DS or 1LW) -
Volvo All Engines (2013 Emissions) Fault Code: P115213 PID: EMS Fuel Priming Pump
All Engines (2013 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P00C600 PID: EMS Fuel Rail Pressure Too Low – Engine Cranking
All Engines (2017 Emissions) -
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 61 PID: 110 SPN: FMI: 11 Very High Coolant Temperature
3406E (Prefix 5DS or 1LW) -
Volvo All Engines (2017 Emissions) Fault Code: P040985 PID: EMS EGR Differential Pressure Sensor
All Engines (2017 Emissions)