CAT 3406E (Prefix 5DS or 1LW) Fault Code: 36 PID: 84 SPN: FMI: 10 Vehicle Speed signal rate of change
The ECM detects the following conditions:
•The vehicle speed signal changes more than 5 MPH on eight consecutive readings in three seconds.
•The engine speed is greater than the programmed “VSL Protection” minus 100 rpm.
•The “VSL Protection” parameter is programmed to a value that is less than 2120 rpm.
Probable Causes:
1) Fuel system restriction (Uncommon, but possible)
2) If speedometer is not accurate, then ECM is not programmed correctly
3) Vehicle speed sensor
4) Vehicle speed sensor wiring
5) ECM Connection/Harness
6) Speedometer failure
7) ECM Failure
![DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software](https://i0.wp.com/www.ecuforcetruck.com/wp-content/uploads/2023/11/1.png?resize=300%2C300&ssl=1)
![DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software](https://www.ecuforcetruck.com/wp-content/uploads/2023/11/Captura-1.png)
