Cummins ISB CM550 (1990-94) Fault Code: 386 PID: SID 232 SPN: 620 FMI: 4 Sensor Suppy Circuit
Circuit Description
The engine position sensor (EPS), the intake manifold pressure sensor, and the oil pressure
sensor are powered by the same +5-VDC source and the same return in the electronic control
module (ECM). This supply is also used to operate the intake manifold temperature and
coolant temperature sensors.
Component Location
The +5-VDC sensor supply circuit is located in the sensor harness. See Section E of this
manual for the sensor locations.
Shop Talk
These faults could also cause high- or low-voltage faults on the coolant temperature and intake
manifold temperature sensors.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00
