Shop
Account
Cart $420.00
2
2
Subtotal: $420.00
The ISUZU G-IDSS Domestic Japan 2024 is an advanced diagnostic tool designed for Isuzu vehicles. This version introduces several key features that enhance vehicle maintenance and streamline diagnostics. With improved user interfaces and multi-language support, technicians can efficiently navigate the system. The G IDSS also offers advanced programming capabilities, allowing for precise control updates and accurate diagnostics.
ISUZU G-IDSS Domestic Japan 2024 Diagnostic Software
1 × $220.00
CLAAS MetaDiag 2007 Update 2016 is a crucial software tool for diagnosing issues in CLAAS agricultural machinery. It enhances efficiency and supports maintenance activities through advanced features and user-friendly design. This update includes improvements in diagnostic capabilities, compatibility, and installation processes. Designed for easy use, it is vital for technicians managing heavy machinery and trucks, ensuring optimal performance and reduced downtime.
CLAAS MetaDiag 2007 Update 2016
1 × $200.00
Subtotal: $420.00
View cart Checkout

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 351 PID: SID 251 SPN: 627 FMI: 12 Injector Power Supply – Bad Intelligent Device or Component. The ECM measured injector boost voltage is low.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable fixes to the calibration stored in the ECM. If necessary, recalibrate the ECM.

This fault code will become active when the engine is running, the primary engine speed sensor signal is present, the battery charge is above a minimum threshold, and, at the same time, the measured injector power supply voltage is lower than the commanded injector power supply voltage.

This fault code will become inactive whenever the keyswitch is turned on.

This fault code will become inactive whenever the engine is running and measured injector power supply voltage reaches the commanded injector power supply voltage.

Possible repairs:

1)Clean the battery terminal connections.
2)Replace the ECM.

Categories , , Tags , , , , , , , , , , , , , , , , , , , , , , , ,
Facebook Twitter Youtube
Wiring Diagrams
Component Locators

Related products