Cummins ISB6.7 CM2350 (2013-17) Fault Code: 4517 PID: SPN: 237 FMI: 13 Vehicle Identification Number – Out of Calibration. The vehicle identification number has not been programmed into the ECM.

Cummins ISB6.7 CM2350 (2013-17) Fault Code: 4517 PID: SPN: 237 FMI: 13 Vehicle Identification Number – Out of Calibration. The vehicle identification number has not been programmed into the ECM.

Circuit Description
Messages sent from OEM VECUs or transmission ECUs are received by the Cummins? ECM and used for controlling the engine. The Cummins? ECM and OEM VECU(s) must be configured properly, so that proper operation of the multiplexed components will occur.

Component Location
The Engine Control Module (ECM) is mounted on the intake manifold side of the engine.

Conditions for Running the Diagnostics
This diagnostic runs continuously when the keyswitch is in the ON position or when the engine is running.

Conditions for Setting the Fault Codes
The Engine Control Module (ECM) detected the vehicle identification number (VIN) was not programmed in the ECM.

Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp and/or the Malfunction Indicator Lamp (MIL) immediately when the diagnostic runs and fails.

Conditions for Clearing the Fault Code
1)To validate the repair, perform a key cycle, and leave the key in the ON position for 1 minute.
2)The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
3)The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
4)For On-Board Diagnostics (OBD) engines, the ECM will extinguish the Malfunction Indicator Lamp (MIL) after three consecutive trips where the diagnostic runs and passes.
5)The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.

Possible causes:
1)Incorrect feature and parameter settings