Cummins ISM CM875 (2003-06) Fault Code: 482 PID: P094 SPN: 94 FMI: 1/18 Fuel Pressure Low – Data Valid But Below Normal Operating Range – Moderately Severe Level.
The fuel pressure is monitored by the ECM. If the rail fuel pressure is lower than an acceptable level for a given set of engine operating conditions, the fault code is logged.
Possible causes:
1)A damaged or sticking drain-back valve located in the fuel supply circuit in the integrated fuel system module (IFSM). The IFSM is located directly above the fuel lift pump.
Possible repairs:
1)Fill the fuel tanks.
2)Prime the fuel system.
3)Repair or replace the fuel lift pump.
4)Repair or replace the fuel shutoff valve.
5)Replace the 1724 kPa [250 psi] regulator.
6)Replace the suction-side fuel filter or repair the cause of high inlet restriction.
7)Repair or replace the fuel shutoff valve.
8)Replace the pressure fuel filter.
9)Replace the rail fuel pressure sensor.
![MAN MANTIS v666 EPC [09.2021] Spare Parts Catalog](https://www.ecuforcetruck.com/wp-content/uploads/2022/01/MANTIS-V666-300x300.png)
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00
