Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 4572 PID: SPN: 3031 FMI: 9 Aftertreatment 1 Diesel Exhaust Fluid tank Temperature- Abnormal Update Rate
The aftertreatment diesel exhaust fluid tank temperature sensor is used to monitor the temperature of the aftertreatment diesel exhaust fluid inside the aftertreatment diesel exhaust fluid tank.
The aftertreatment diesel exhaust fluid tank temperature sensor is located in the diesel exhaust fluid tank. Location of the tank and temperature sensor is OEM dependent. Refer to the OEM service manual.
Conditions for Running the Diagnostics
This diagnostic runs continuously when the keyswitch is in the ON position or when the engine is running.
Conditions for Setting the Fault Codes
The Engine Control Module (ECM) detected a loss of communication with the aftertreatment diesel exhaust fluid tank temperature sensor.
Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp and/or the Malfunction Indicator Lamp (MIL) immediately when the diagnostic runs and fails.
Diesel exhaust fluid injection into the aftertreatment system is disabled.
Engine torque will be reduced if the engine is operated for an extended period of time with this fault active.
Conditions for Clearing the Fault Code
To validate the repair, perform a key cycle, start the engine and let it idle for 1 minute.
The fault code status displayed by INSITE™ electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
For On-Board Diagnostics (OBD) engines, the ECM will extinguish the Malfunction Indicator Lamp (MIL) after three consecutive trips where the diagnostic runs and passes.
The Reset All Faults command in INSITE™ electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.
Possible causes of this fault code include:
Incorrect terminating resistance of the SAE J1939 datalink circuit
Intermittent communication from the aftertreatment diesel exhaust fluid tank temperature sensor
An open or short circuit in the SAE J1939 datalink circuit
1) ECM calibration
Detroit Diesel Drumroll Engineering 7.06 DDDE v7.06Detroit $20.00
Volvo PROSIS Offline 2019 Parts Catalog Installation ServiceTrucks software $45.00
CUMMINnSsg INSITEr 188.8.131.52 PRO + ZAP-ITcummisznn $70.00
Navkal 2018 offline version remove DPF MAXXFORCE 13 EPA 10Navistar $50.00
DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software 1PCDOOSAN $106.00
SERVICE MANUAL BENDIX EC-60BENDIX $17.00
SERVICE MANUAL MACK V-MAC IIMACK $28.00
SERVICE MANUAL BOBCAT 3400 smsBOBCAT $40.00
SERVICE MANUAL BOBCAT 943 smsBOBCAT $40.00
SERVICE MANUAL BOBCAT 963 smsBOBCAT $57.00
MANUAL SERVICE DEUTZ AGROKID 30-40-50DEUTZ $20.00
SERVICE MANUAL Carrie 40 and 50 XCARRIE $20.00
SERVICE MANUAL BOBCAT 641-642-643 smsBOBCAT $47.00
SERVICE MANUAL MACK V-MAC IV 2007 EMISSIONSMACK $27.00