Detroit DD16 EPA10 (2010-13) Fault Code: SPN 4100 FMI 13 (MCM, ACM) Motor Control Module or the Aftertreatment Control Module Software Not Compatible
NOTE: This fault indicates the vehicle contains incompatible motor control module (MCM) or the aftertreatment control module (ACM) software versions. Clear the fault, and if fault again becomes active, MCM/ACM software must be reprogrammed to the correct level. If fault does not become active, release the vehicle.
NOTE: Please see the step by step troubleshooting procedures for this specific code.
NOTE: The engine ECMs need to be reprogrammed to the correct levels.
![Magic Tuner [paccar, Maxxforce, Detroit, Caterpillar, Delete]](https://www.ecuforcetruck.com/wp-content/uploads/2021/10/1-300x300.png)
Related products
-
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
