PACCAR MX (2004 Emissions) Fault Code: P0503 Vehicle Speed Sensor – Out of Range
PACCAR MX (2004 Emissions) Fault Code: P0503 Vehicle Speed Sensor – Out of Range
SET CONDITIONS:
The PCI ECU (D420) detects that the measured vehicle speed is higher than 140 km/h [87 mph].
DIAGNOSTIC CONDITION:
This diagnostic runs continuously after ignition is keyed on.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. Driving at high speed (e.g., downhill)
2. Faulty vehicle speed signal
ADDITIONAL INFORMATION:
1. The PCI ECU uses the vehicle speed sensor as an input for the vehicle speed.
2. When this DTC is detected five times during one drive cycle, it stays active. A drive cycle is the period between ignition on and off with the diagnostic condition met. After 4 hours of continuous ignition on or engine operation, a new drive cycle is started.
-
CLAAS WebTIC Offline [11.2021] Service Information – ENGLISH Language
CLAAS $100.00Rated 0 out of 5 -
download MANCATS II v14.01 2014 Diagnostic software MAN CATS ( virtual machine )
MAN $75.00Rated 0 out of 5
-
CAT CDVR PC Software – Caterpillar Digital Voltage Regulator (CDVR) WINDOWS 10
CAT $45.00Rated 0 out of 5 -
2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )
Trucks software $85.00Rated 0 out of 5 -
volvo Devtool Studio V2 / V3 / V4 Developer tool plus 2.6 / 2.7
Trucks software $35.00Rated 0 out of 5 -
Eaton Service Ranger 4.9 Engineering 4.9 [05.2021] Engineering Level ( 1 PC )
Eaton $67.00Rated 0 out of 5
Related products
-
SERVICE MANUAL International Engines MaxxForce 5 (2007 & 2009)
INTERNATIONAL ENGINES $25.00Rated 0 out of 5