Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 11 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) Abnormal value
Observable symptoms
1) Power loss
Probable cause
1) Intake manifold air temperature (IMAT) and pressure sensor
2) Wiring harness
3) Charge air system leakage
![International Truck ISIS - Oncommand Service Information Q4.2020 [04.2020]](https://www.ecuforcetruck.com/wp-content/uploads/2022/01/OnCommand-2020-1-300x300.png)
Related products
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 654 FMI 7 PID: SID 4 Engine Injector Cylinder 4
All Engines (2010 Emissions) -
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P009511 PID: EMS Intake Air Temperature Sensor 2 Bank 1
All Engines (2013 Emissions) -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: U30004B PID: EMS Electronic Control Unit
All Engines (2017 Emissions) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P25A971 PID: EMS Piston Cooling Oil Control
All Engines (2013 Emissions) -
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 36 PID: SPN: 84 FMI: 10 Vehicle Speed signal rate of change
3406E (Prefix 1MM or 2WS)
