Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 11 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) Abnormal value
Observable symptoms
1) Power loss
Probable cause
1) Intake manifold air temperature (IMAT) and pressure sensor
2) Wiring harness
3) Charge air system leakage
Related products
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P102113 PID: EMS Volvo Compression Brake (VCB) Control Circuit
All Engines (2013 Emissions) -
-
-
-
Volvo Engine D12D AE E3 (Tier 3) Fault Code: SID21 FMI 3 Engine Position
D12D AE E3 (Tier 3) -
-
-
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 108 FMI 4 PID: Barometric Pressure
All Engines (2010 Emissions) -
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 65 PID: 174 SPN: FMI: 0 High Fuel Temperature Warning
3406E (Prefix 5DS or 1LW) -
