Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 16 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) Charge pressure High
Observable symptoms
1) Engine derate according to error torque map
Probable cause
1) Intake manifold air temperature (IMAT) and pressure sensor
2) Actuator
3) By-pass shutter
Related products
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P21CA00 PID: ACM Reductant Control Module Supply Voltage
All Engines (2017 Emissions) -
-
Allison 1000 & 2000 Gen 5 Fault Code:P0561 System Voltage – Performance
1000 & 2000 Gen 5 -
-
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 100 FMI 1 (CPC) Oil Pressure Very Low
DD15 EPA10 (2010-13) -
-
-
-
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P203D00 PID: ACM Aftertreatment Reagent Level Short Circit High
All Engines (2013 Emissions)
