Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 17 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) Charge pressure Low
Probable cause
1) Wiring harness
2) Intake manifold air temperature (IMAT) and pressure sensor
Related products
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P040C00 PID: EMS Exhaust Gas Recirculation Temperature Sensor “A”
All Engines (2017 Emissions) -
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 100 FMI 3 PID: Engine Oil Pressure
All Engines (2010 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P229E12 PID: EMS NOx Sensor Bank 1 Sensor 2
All Engines (2017 Emissions) -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P114970 PID: EMS Intake Air Heater “B” Circuit
All Engines (2017 Emissions) -
-
Volvo All Engines (2017 Emissions) Fault Code: P220093 PID: EMS NOx Sensor Bank 1 Sensor 1
All Engines (2017 Emissions) -
-
-
