Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 9 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) Abnormal value : Low
Observable symptoms
1) Power loss
2) Black smoke
Probable cause
1) Wiring harness
2) Intake manifold air temperature (IMAT) and pressure sensor connector
3) Charge air system leakage
Related products
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P009400 PID: EMS Fuel System Leak Detected – Small Leak
All Engines (2013 Emissions) -
Volvo All Engines (2004 Emissions) Fault Code: PID 105 FMI 5 Boost Air Pressure / Temperature Sensor
All Engines (2004 Emissions) -
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P26E712 PID: ACM Actuator Supply Voltage “D” Circuit High
All Engines (2013 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P054001 PID: EMS Intake Air Heater “A” Control
All Engines (2017 Emissions) -
-
-
-
-
-
