Volvo All Engines (2010 Emissions) Fault Code: SPN 105 FMI 0 PID: Engine Intake Manifold 1 Temperature
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) Charge air temperature too high
Probable cause
1) Intake manifold air temperature (IMAT) and pressure sensor
2) Extreme driving conditions
3) Poor cooling
Detailed information
1) High ambient temperature can cause an active diagnostic trouble code (DTC)
Related products
-
-
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 190 FMI 0 (MCM) Engine Over Speed
DD13 EPA10 (2010-13) -
Volvo All Engines (2017 Emissions) Fault Code: P027600 PID: EMS Cylinder 6 Injector Circuit Low
All Engines (2017 Emissions) -
-
-
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P208A13 PID: EMS Reductant Pump “A” Control
All Engines (2017 Emissions) -
-
Volvo All Engines (2013 Emissions) Fault Code: P26977A PID: EMS Exhaust Aftertreatment Fuel Injector “A”
All Engines (2013 Emissions) -
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 00 PID: SPN: 224 FMI: 11 Theft Deterrent Active
3406E (Prefix 1MM or 2WS) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P225112 PID: EMS O2 Sensor Negative Current Control Bank 1 Sensor 1
All Engines (2013 Emissions) -
