Volvo All Engines (2010 Emissions) Fault Code: SPN 105 FMI 10 PID: Engine Intake Manifold 1 Temperature
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is stuck
Probable cause
1) Charge air temperature sensor
Related products
-
-
-
-
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 723 FMI 14 (MCM) Swapped Pins
DD16 EPA07 (2007-09) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P208E00 PID: ACM Aftertreatment Reagent Dosing Valve Clogged
All Engines (2013 Emissions) -
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P245211 PID: ACM Particulate Filter Pressure Sensor “A”
All Engines (2013 Emissions) -
-
Volvo All Engines (2017 Emissions) Fault Code: P101713 PID: EMS Water in Fuel Drainage Valve
All Engines (2017 Emissions) -
-
-
