Volvo All Engines (2010 Emissions) Fault Code: SPN 105 FMI 10 PID: Engine Intake Manifold 1 Temperature
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is stuck
Probable cause
1) Charge air temperature sensor
Related products
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P054415 PID: ACM Exhaust Gas Temperature Sensor Bank 1 Sensor 1
All Engines (2013 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P20CA00 PID: ACM Reductant Injection Air Pressure Leakage
All Engines (2013 Emissions) -
-
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 34 PID: SPN: 190 FMI: 12 Primary Engine Speed loss of signal
3406E (Prefix 1MM or 2WS) -
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P203900 PID: ACM Reductant Injection Air Pressure Sensor “A”
All Engines (2017 Emissions) -
