Volvo All Engines (2010 Emissions) Fault Code: SPN 105 FMI 17 PID: Engine Intake Manifold 1 Temperature
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is not rational
Probable cause
1) Intake manifold air temperature (IMAT) and pressure sensor
Related products
-
PACCAR MX (2004 Emissions) Fault Code: P1601 PCI ECU – Internal Error
MX (2004 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P208A00 PID: ACM Reductant Pump “A” Control
All Engines (2017 Emissions) -
-
-
PACCAR MX (2004 Emissions) Fault Code: P1194 Fuel Filter – Very Clogged
MX (2004 Emissions) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P100192 PID: EMS Engine Stop Switch
All Engines (2013 Emissions) -
-
-
-
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 709 FMI 4 (MCM, CPC) Short to Ground
DD15 EPA10 (2010-13) -
-
-
-
-
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 709 FMI 4 (MCM, CPC) Short to Ground
DD13 EPA10 (2010-13)
