Volvo All Engines (2010 Emissions) Fault Code: SPN 105 FMI 2 PID: Engine Intake Manifold 1 Temperature
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is not rational
Probable cause
1) Intake Manifold Pressure/Temperature Sensor
2) Wiring harness
-
Volvo Premium Tech Tool PTT 2.8.130 Diagnostic Software 04.2022 ACPI ( 1 PC )
Trucks software $143.00 -
-
-
-
-
-
-
-
-
-
-
-
-
-
Related products
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P066800 PID: EMS PCM/ECM/TCM Internal Temperature Sensor Circuit Low
All Engines (2013 Emissions) -
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 3720 FMI 0 PID: PPID 337 Aftertreatment DPF Ash Load Percent
All Engines (2010 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P009B12 PID: EMS Fuel Pressure Relief Control
All Engines (2013 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P020613 PID: EMS Cylinder 6 Injector “A”
All Engines (2017 Emissions) -
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P268D00 PID: EMS Cylinder 2 Injector Data Incompatible
All Engines (2013 Emissions) -
Allison 3000 & 4000 Gen 4 Fault Code: P0880 TCM Power Input Signal
3000 & 4000 Gen 4 -
