Volvo All Engines (2010 Emissions) Fault Code: SPN 105 FMI 2 PID: Engine Intake Manifold 1 Temperature
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is not rational
Probable cause
1) Intake Manifold Pressure/Temperature Sensor
2) Wiring harness
Related products
-
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P0735 Incorrect 5th Gear Ratio
1000 & 2000 Gen 5 -
Volvo All Engines (2013 Emissions) Fault Code: P205A64 PID: EMS Reductant Tank Temperature Sensor
All Engines (2013 Emissions) -
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 97 FMI 15 (MCM) Water-In-Fuel Warning
DD13 EPA10 (2010-13) -
Volvo All Engines (2017 Emissions) Fault Code: P117411 PID: EMS Transmission Range Request
All Engines (2017 Emissions) -
-
-
-
