The engine control module (ECM) monitors the intake manifold pressure (IMP) sensor and controls the boost air system (mainly controlled by the VGT) and the engine turbocharger compressor bypass valve. The ECM also uses parameters like engine speed (RPM) and turbocharger speed to make a calculation of the IMP. This estimated value should not differ too much from the measured value.
Conditions for diagnostic trouble code (DTC):
1) Poor intake manifold pressure (IMP) response
Observable symptoms
1) Power loss
2) Poor response
Probable cause
1) Charge air system leakage
-
Wabco ToolBox plus 13.7 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software $84.00Rated 0 out of 5 -
JOHN DEERE SERVICE ADVISOR 5.3.225 DATABASE AG + CF ENGLISH 2023
John Deere $250.00Rated 0 out of 5 -
International Truck ISIS – Oncommand Service Information Q4.2020 [04.2020]
Navistar $85.00Rated 0 out of 5 -
premium volvo tech tool update 2.8.150 diagnostic software 1pc
Trucks software $150.00Rated 0 out of 5
Related products
-
Volvo All Engines (2004 Emissions) Fault Code: PID 110 FMI 5 Engine Coolant Temperature Sensor
All Engines (2004 Emissions)Rated 0 out of 5 -
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 723 FMI 14 (MCM) Swapped Pins
DD15 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 679 FMI 7 (MCM) Pressure Limiting Valve (PLV) Staying Open
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 636 FMI 8 (MCM) Crankshaft Position Sensor Time Out
DD16 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 520323 FMI 4 (ACM) High Side Digital Output Circuit Failed Low
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 13 (MCM) Diagnostic Message Not Received this Ignition Cycle
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Volvo All Engines (2017 Emissions) Fault Code: P040913 PID: EMS EGR Differential Pressure Sensor
All Engines (2017 Emissions)Rated 0 out of 5 -
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 609 FMI 12 (MCM) Motor Control Module Failed or Programmed Incorrectly
DD13 EPA07 (2007-09)Rated 0 out of 5 -
Allison WTEC II Fault Code : 21 PID: SPN: 12 FMI: Throttle position sensor, failed low
AllisonRated 0 out of 5