The engine control module (ECM) monitors the intake manifold pressure (IMP) sensor and controls the boost air system (mainly controlled by the VGT) and the engine turbocharger compressor bypass valve. The ECM also uses parameters like engine speed (RPM) and turbocharger speed to make a calculation of the IMP. This estimated value should not differ too much from the measured value.
Conditions for diagnostic trouble code (DTC):
1) Charge pressure Low
Observable symptoms
1) High soot level
2) Low Power
Probable cause
1) Charge air system leakage
2) Turbocharger
3) Charge air pressure sensor
4) Air Cleaner (ACL)
5) Faulty VGT position – The sensor shows a more closed position than the actual position
6) Faulty EGR position – Valve more open than it is supposed to
Related products
-
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 628 FMI 14 (CPC) XFLASH Failure
DD13 GHG14 (2014-16) -
Volvo All Engines (2013 Emissions) Fault Code: P020E25 PID: EMS Cylinder 5 Injection Timing
All Engines (2013 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P011013 PID: EMS Intake Air Temperature Sensor 1 Bank 1
All Engines (2017 Emissions) -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 91 FMI 2 (CPC) Erratic Data
DD13 EPA10 (2010-13) -
Volvo All Engines (2017 Emissions) Fault Code: P040A11 PID: EMS Exhaust Gas Recirculation Temperature Sensor “A”
All Engines (2017 Emissions) -
Volvo All Engines (2004 Emissions) Fault Code: SID 5 FMI 3 Fuel Injector Unit #5
All Engines (2004 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P020C25 PID: EMS Cylinder 3 Injection Timing
All Engines (2013 Emissions)