The engine control module (ECM) monitors the intake manifold pressure (IMP) sensor and controls the boost air system (mainly controlled by the VGT) and the engine turbocharger compressor bypass valve. The ECM also uses parameters like engine speed (RPM) and turbocharger speed to make a calculation of the IMP. This estimated value should not differ too much from the measured value.
Conditions for diagnostic trouble code (DTC):
1) Charge pressure Low
Observable symptoms
1) High soot level
2) Low Power
Probable cause
1) Charge air system leakage
2) Turbocharger
3) Charge air pressure sensor
4) Air Cleaner (ACL)
5) Faulty VGT position – The sensor shows a more closed position than the actual position
6) Faulty EGR position – Valve more open than it is supposed to
Related products
-
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 97 FMI 15 (MCM) Water-In-Fuel Warning
DD16 EPA10 (2010-13) -
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 14 PID: 121 SPN: FMI: 5 Low/High Retarder current low
3406E (Prefix 5DS or 1LW) -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 713 FMI 4 (CPC) Short to Ground Circuit
DD15 GHG14 (2014-16) -
Volvo All Engines (2017 Emissions) Fault Code: P113800 PID: EMS Engine Rear Start Switch “A” Circuit Low
All Engines (2017 Emissions)