Volvo All Engines (2010 Emissions) Fault Code: SPN 1675 FMI 7 PID: SID 39 Engine Starter Mode
The (VECU) Vehicle Electronic Control Unit supplies and monitors the cranking signal to the starter motor relay. Several types of starter cranking protection are provided so the starter cannot be engaged in unwanted conditions. The starter cranking protection will also limit the maximum cranking time to 18 seconds without cycling the key.
Conditions for diagnostic trouble code (DTC):
1) Transmission is not in neutral position
2) Gear selector not in neutral
3) Only for automatic transmission
Observable symptoms
1) Not possible to activate the starter motor
Probable cause
1) Transmission
2) Gear selector
Detailed information
1) Put the gear selector in neutral position and try to start again
2) When the vehicle is equipped with manual transmission the parameter code BZN in ECM should be set to 0
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Volvo Premium Tech Tool PTT 2.8.130 Diagnostic Software 04.2022 ACPI ( 1 PC )
Trucks software $143.00 -
Related products
-
-
-
-
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 636 FMI 14 (MCM) Swapped Pins
DD13 GHG14 (2014-16) -
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 32 PID: SPN: 91 FMI: 8 Throttle Signal Invalid
3406E (Prefix 1MM or 2WS) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 2003 FMI 9 PID: PSID 205 Transmission Control Module (TCM) Status
All Engines (2010 Emissions) -
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 412 FMI 16 PID: Engine Exhaust Gas Recirculation Temperature
All Engines (2010 Emissions) -
-
-
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 723 FMI 3 (MCM) Open Circuit
DD15 GHG14 (2014-16) -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P050600 PID: EMS Idle Control System – RPM Lower Than Expected
All Engines (2017 Emissions)
