The Engine Oil Level/Temperature Sensor contains two thermistors, one for engine oil temperature and one for engine oil level. The resistance of the engine oil temperature portion of the sensor changes inversely to the temperature of the engine oil. When the engine oil is cold, the sensor resistance is high. As the temperature of the engine oil increases, the sensor resistance decreases.
The Engine Control Module (ECM) monitors the voltage drop across the sensor and uses this signal to warn the driver and derate the engine to avoid engine damage if the signal is not within programmed limits.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:31 is below normal value
Observable symptoms
1) The engine oil temperature (EOT) is continously shown as 0 when the engine is running
Probable cause
1) Engine oil level (EOL) and temperature sensor
2) Short circuit to ground, Signal wire
3) Connector
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Volvo All Engines (2013 Emissions) Fault Code: P117B01 PID: EMS Engine Compartment Temperature Sensor Switch
All Engines (2013 Emissions) -
Volvo All Engines (2004 Emissions) Fault Code: PID 26 FMI 3 Fan Speed
All Engines (2004 Emissions) -
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 100 FMI 1 (MCM) Low Engine Oil Pressure
DD13 EPA07 (2007-09)