The function identifies and indicates malfunction of the aftertreatment diesel particulate filter (DPF) by analyzing the pressure drop over the aftertreatment DPF. This is done by making a check for deviation between sensor value and a model pressure drop. In some extreme cases the engine will derate.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A137:26 is more than 4.75?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Ground wire
3) Short circuit to 5V, Signal wire
4) Short circuit to battery voltage, Signal wire
5) Wiring harness
6) Aftertreatment DPF Differential Pressure Sensor
7) Aftertreatment Control Module (ACM)
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5
-
Volvo All Engines (2013 Emissions) Fault Code: P203D00 PID: ACM Aftertreatment Reagent Level Short Circit High
All Engines (2013 Emissions) -
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 47 PID: SPN: 71 FMI: 14 PTO Shutdown
3406E (Prefix 1MM or 2WS) -
Volvo All Engines (2013 Emissions) Fault Code: P255612 PID: EMS Engine Coolant Level Sensor/Switch
All Engines (2013 Emissions) -
Allison 3000 & 4000 Gen 4 Fault Code: P278A Kickdown Input Failed ON
3000 & 4000 Gen 4