“John Deere Service Advisor 5.4.44 2025 (AG & CF) | Nexiq USB Link 3 Compatible” has been added to your cart. View cart
The function identifies and indicates malfunction of the aftertreatment diesel particulate filter (DPF) by analyzing the pressure drop over the aftertreatment DPF. This is done by making a check for deviation between sensor value and a model pressure drop. In some extreme cases the engine will derate.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A137:26 is less than 0.27?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Signal wire
3) Open circuit, Supply wire
4) Short circuit to ground, Signal wire
5) Wiring harness
6) Aftertreatment DPF Differential Pressure Sensor
7) Aftertreatment Control Module (ACM)
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5
-
Volvo All Engines (2017 Emissions) Fault Code: P011011 PID: EMS Intake Air Temperature Sensor 1 Bank 1
All Engines (2017 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P269711 PID: EMS Exhaust Aftertreatment Fuel Injector “A”
All Engines (2017 Emissions) -
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 723 FMI 4 (MCM) Short to Ground
DD13 EPA07 (2007-09) -
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 709 FMI 4 (MCM, CPC) Short to Ground
DD15 EPA10 (2010-13) -
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 25 PID: 102 SPN: FMI: 3 Boost Pressure voltage high
3406E (Prefix 5DS or 1LW)