“CAT ET 2026 Diagnostic Software” has been added to your cart. View cart
The function identifies and indicates malfunction of the aftertreatment diesel particulate filter (DPF) by analyzing the pressure drop over the aftertreatment DPF. This is done by making a check for deviation between sensor value and a model pressure drop. In some extreme cases the engine will derate.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A137:26 is less than 0.27?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Signal wire
3) Open circuit, Supply wire
4) Short circuit to ground, Signal wire
5) Wiring harness
6) Aftertreatment DPF Differential Pressure Sensor
7) Aftertreatment Control Module (ACM)
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5
-
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 558 FMI 3 (CPC) Open Circuit
DD13 EPA10 (2010-13) -
Volvo All Engines (2013 Emissions) Fault Code: P054011 PID: EMS Intake Air Heater “A” Control
All Engines (2013 Emissions)