Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 3 PID: PPID 437 Aftertreatment DPF Fuel Pressure
During DPF regeneration the Aftertreatment Fuel Pressure Sensor monitors the fuel pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. During Air Purge the Aftertreatment Fuel Pressure Sensor monitors the air pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. The Engine Control Module (ECM) uses this input to determine if the system is operating correctly.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:50 is more than 4.8?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit on ground wire
3) Short circuit to voltage supply, signal wire
4) Aftertreatment Fuel Pressure Sensor
5) Engine control module (ECM)
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P025614 PID: EMS Injection Pump Fuel Metering Control “B”
All Engines (2013 Emissions) -
-
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 558 FMI 3 (CPC) Open Circuit
DD13 EPA10 (2010-13) -
Volvo All Engines (2013 Emissions) Fault Code: P114970 PID: EMS Intake Air Heater “B” Circuit
All Engines (2013 Emissions) -
-
Volvo All Engines (2013 Emissions) Fault Code: P020556 PID: EMS Cylinder 5 Injector “A”
All Engines (2013 Emissions) -
-
-
-
-
-
Volvo All Engines (2004 Emissions) Fault Code: SID 230 FMI 5 Idle Validation Switch
All Engines (2004 Emissions) -
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 412 FMI 15 PID: Engine Exhaust Gas Recirculation Temperature
All Engines (2010 Emissions) -
-
