Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 3 PID: PPID 437 Aftertreatment DPF Fuel Pressure
During DPF regeneration the Aftertreatment Fuel Pressure Sensor monitors the fuel pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. During Air Purge the Aftertreatment Fuel Pressure Sensor monitors the air pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. The Engine Control Module (ECM) uses this input to determine if the system is operating correctly.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:50 is more than 4.8?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit on ground wire
3) Short circuit to voltage supply, signal wire
4) Aftertreatment Fuel Pressure Sensor
5) Engine control module (ECM)
Related products
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
-
-
-
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 3603 FMI 9 (CPC) ESS Message is Missing
DD15 EPA07 (2007-09) -
-
Volvo All Engines (2013 Emissions) Fault Code: P00C600 PID: EMS Fuel Rail Pressure Too Low – Engine Cranking
All Engines (2013 Emissions) -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0614 Torque Control Data Mismatch – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
Volvo All Engines (2017 Emissions) Fault Code: P268F00 PID: EMS Cylinder 4 Injector Data Incompatible
All Engines (2017 Emissions) -
-
Volvo All Engines (2013 Emissions) Fault Code: P204213 PID: ACM Reductant Temperature Sensor
All Engines (2013 Emissions)
