Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 3 PID: PSID 108 Aftertreatment DPF Fuel Pressure
During DPF regeneration the Aftertreatment Fuel Pressure Sensor monitors the fuel pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. During Air Purge the Aftertreatment Fuel Pressure Sensor monitors the air pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. The Engine Control Module (ECM) uses this input to determine if the system is operating correctly.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:50 is more than 4.8?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit on ground wire
3) Short circuit to voltage supply, signal wire
4) Aftertreatment Fuel Pressure Sensor
5) Engine control module (ECM)
Related products
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5 -
-
-
-
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 723 FMI 4 (MCM) Short to Ground
DD15 GHG14 (2014-16) -
-
Volvo All Engines (2017 Emissions) Fault Code: P047F00 PID: EMS Exhaust Pressure Control Valve “A” Stuck Open
All Engines (2017 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: U300046 PID: EMS Electronic Control Unit
All Engines (2013 Emissions) -
-
-
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 1127 FMI 14 PID: PSID 98 Engine Turbocharger 1 Boost Pressure
All Engines (2010 Emissions) -
-
Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 7 Starter Output
All Engines (2004 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P242A11 PID: ACM Exhaust Gas Temperature Sensor Bank 1 Sensor 3
All Engines (2013 Emissions) -
-
