Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 5 PID: PPID 437 Aftertreatment DPF Fuel Pressure
During DPF regeneration the Aftertreatment Fuel Pressure Sensor monitors the fuel pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. During Air Purge the Aftertreatment Fuel Pressure Sensor monitors the air pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. The Engine Control Module (ECM) uses this input to determine if the system is operating correctly.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:50 is less than 0.2?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Supply wire
3) Open circuit, Signal wire
4) Short circuit to ground, Signal wire
5) Aftertreatment Fuel Pressure Sensor
6) Engine control module (ECM)
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
-
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5
-
-
Volvo All Engines (2004 Emissions) Fault Code: PID 102 FMI 5 Boost Air Pressure / Temperature Sensor
All Engines (2004 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 636 FMI 3 PID: SID 21 Camshaft Position Sensor (CMP)
All Engines (2010 Emissions) -
-
-
-
-
-
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 91 FMI 4 (CPC) Circuit Failed Low
DD15 EPA07 (2007-09) -
-
-
Volvo All Engines (2017 Emissions) Fault Code: P25AE00 PID: EMS Piston Cooling Oil Pressure Too Low
All Engines (2017 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P020156 PID: EMS Cylinder 1 Injector “A”
All Engines (2013 Emissions) -
-
-
