Volvo All Engines (2010 Emissions) Fault Code: SPN 3484 FMI 5 PID: Aftertreatment Ignition
The aftertreatment control module (ACM) supplies a pulsed ground signal to activate the ignition coil. The ignition coil is connected to the ignition electrodes by two ignition wires. When activated it supplies 40,000 to 45,000 volts to the ignition electrodes creating an arc that ignites the atomized fuel and air mixture in the aftertreatment diesel particulate filter (DPF) combustion chamber of the aftertreatment DPF.
Conditions for diagnostic trouble code (DTC):
1) Pin: 13 (Control wire (-)), Current below normal or open circuit
Observable symptoms
1) Regeneration not possible
Probable cause
1) Wiring harness between Aftertreatment ignition coil and Aftertreatment Control Module (ACM)
2) Aftertreatment ignition coil
3) Aftertreatment Control Module (ACM)
Related products
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
Volvo Engine D12D AE E3 (Tier 3) Fault Code: SID254 FMI 3 Controller 1
D12D AE E3 (Tier 3) -
-
-
-
-
-
-
-
Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 4 Starter Output
All Engines (2004 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 3491 FMI 5 PID: Aftertreatment DPF Atomization Air Actuator
All Engines (2010 Emissions) -
-
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 26 PID: SPN: 108 FMI: 4 Atmospheric Pressure voltage low
3406E (Prefix 1MM or 2WS) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 111 FMI 18 PID: Engine Coolant Level – Moderately Severe Level
All Engines (2010 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 3245 FMI 5 PID: PPID 436 Aftertreatment DPF Outlet Temperature
All Engines (2010 Emissions) -
