The oil thermostat is located in the oil filter housing and controls the engine oil temperature by controlling if the oil is sent through the oil cooler or not. The Engine Control Module (ECM) monitors that the thermostat is working as expected by comparing the Engine Oil Pressure (EOP) Sensor value to a calculated oil temperature.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:53 is between 33?% and 67?% of the battery voltage
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Increased fuel consumption
2) Low oil temperature
Probable cause
1) Open circuit on common supply wire or open circuit on fuse FE9
2) Open circuit in the valve
3) Open circuit in component
Related products
-
Allison 3000 & 4000 Gen 4 Fault Code: P0882 TCM Power Input Signal Low
3000 & 4000 Gen 4 -
Volvo All Engines (2010 Emissions) Fault Code: SPN 153 FMI 14 PID: PSID 23 Engine High Resolution Crankcase Pressure
All Engines (2010 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P20A500 PID: ACM Reductant Purge Control Valve Stuck Closed
All Engines (2013 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P034031 PID: EMS Camshaft Position Sensor “A” Bank 1 or Single Sensor
All Engines (2013 Emissions)