When the aftertreatment selective catalytic reduction (SCR) system operates under normal conditions, the aftertreatment control module (ACM) monitors diesel exhaust fluid (DEF) dosing valve duty cycle and DEF pump control value. When the DEF dosing valve duty cycle increases above allowed threshold and the DEF pump control value decreases below expected threshold, the ACM stops DEF dosing and reports a fault. The fault might be indication of electrical failure or blockage in DEF dosing valve or DEF supply line from the DEF tank.
Conditions for diagnostic trouble code (DTC):
1) Open circuit
Observable symptoms
1) No aftertreatment diesel exhaust fluid (DEF) dosage
Probable cause
1) Connector
2) Wiring harness
3) Aftertreatment diesel exhaust fluid (DEF) dosage valve
4) Dosage electronic control unit (ECU), pump unit
-
2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )
Trucks software $85.00Rated 0 out of 5 -
Navistar international OnCommand service information 2018 software trucks
Navistar $50.00Rated 0 out of 5 -
10 IN 1 FOR CAT SIS Caterpillar 2021 Full Service Dealer INCLUDING CAT 2019 C
CAT $110.00Rated 0 out of 5 -
Volvo Intermediate Storage File Encryptor/Decryptor (Editor) VISFED 0.3.2
Trucks software $35.00Rated 0 out of 5 -
PF Diagnose 2.0.2.23 Diagnostics Software 2013 – Full Heavy & Medium Duty with OBDII Support – Online Installation Service
PF Diagnose $60.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P1891 Throttle Position Sensor (TPS) PWM Signal – Low Input
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P1892 Throttle Position Sensor (TPS) PWM Signal – High Input
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2685 Actuator Supply Circuit Voltage 3 Low (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2727 Pressure Control Solenoid 1 (PCS1) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2684 Actuator Supply Circuit Voltage 3 Open (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2641 Torque Management Feedback Signal – LRTP
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P097C Shift Solenoid 3 (SS3) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2637 Torque Management Feedback Signal – SEM
1000 & 2000 Gen 5Rated 0 out of 5
-
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 706 FMI 5 (CPC) Digital Output 3 10 Circuit Open
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 84 FMI 3 (MCM) Vehicle Speed Sensor Open Circuit
DD15 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 1172 FMI 2 (MCM) Coolant Temperature/Compressor Inlet Temperature Plausibility Error
DD16 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3187 FMI 9 (CPC) CPC has Lost Communication with the DT12 Shift Stalk Lever
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 3480 FMI 31 (MCM) Fuel Cut-Off Valve Pressure Not Plausible
DD15 EPA07 (2007-09)Rated 0 out of 5 -
Allison WTEC II Fault Code: 52 PID: SPN: 79 FMI: Offgoing C3PS test, R to 2 (R to NNC to 2)
AllisonRated 0 out of 5 -
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1172 FMI 4 (MCM) Turbocharger Compressor Inlet Temperature Circuit Failed Low
DD13 EPA07 (2007-09)Rated 0 out of 5