“DETROIT DIESEL DIAGNOSTIC LINK DDDL 8.20 SP1 2025” has been added to your cart. View cart
The preheat Relay controls the preheater from an electric signal from the Engine Control Module (ECM). This function is used to warm up the inlet air during cold conditions. This provides more reliable starting and reduces exhaust emissions during cold starts. Vehicles can be equipped with or without the preheater.
Conditions for diagnostic trouble code (DTC):
1) Output activated
2) Short circuit to battery voltage on A14.EB:25
Observable symptoms
1) Intake air heater (IAH) relay never activated
2) Difficult to start in extreme cold
3) White smoke at cold start
Probable cause
1) Engine wiring harness
2) Connector
3) Intake air heater (IAH) relay
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off
1000 & 2000 Gen 5
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0561 Unrealistic Variations in Vehicle System Voltage
1000 & 2000 Gen 4 $50.00 -
Volvo All Engines (2017 Emissions) Fault Code: P055F00 PID: EMS Engine Oil Pressure Out of Range
All Engines (2017 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P066613 PID: EMS Control Module Internal Temperature Sensor “A”
All Engines (2013 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 94 FMI 17 PID: Engine Fuel Delivery Pressure – Least Severe Level
All Engines (2010 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P009E73 PID: EMS Fuel Pressure Relief Control Performance / Stuck Off
All Engines (2013 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P02E013 PID: EMS Diesel Intake Air Flow Control
All Engines (2013 Emissions) -
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 100 FMI 1 (CPC) Oil Pressure Very Low
DD15 EPA10 (2010-13)